WAN Subsystem Configuration and Management Manual

Configuration Quick Start
WAN Subsystem Configuration and Management Manual—522463-011
1-6
G4SA Naming Conventions (G06.24, G06.25, and
G06.26 RVUs)
cabid
is the group number of the IOAM that contains the G4SA.
module
identifies whether the G4SA is installed in module 2 or 3 of an IOAM. A module is
either 2 or 3.
slot
is the G4SA’s physical slot number in the IOAM:
IOAM position 1-5 + Module
is the IOAM group's position in the topology where one of the IOAMs is connected
to a processor enclosure; this convention uses alphabetical letters A through J:
In the above table, A is Module 2 of the IOAM connected to the first port of the
processor enclosure's ServerNet Expansion Board (SEB).
portid
is the combination of the slot number and port number mapped in the following
way for G4SA; this convention uses alphabetical letters A through U:
In the above table, G is the portid for Port C of the G4SA installed in slot 2 of an
IOAM.
group Description Range of Values
1n The object is in I/O enclosure n. The I/O
enclosure can be physically attached to
as many as four processors in the inner
tetrahedron, but will always have the
processor enclosure number 1.
11,12,13,14,15
Number Description
1 to 5 For the G4SA.
ABCDEFGH I J
1, 2 1, 3 2, 2 2, 3 3, 2 3, 3 4, 2 4,3 5, 2 5, 3
Slot 1Slot 2Slot 3Slot 4Slot 5Port Number
AEI MRA
BFJ NSB
CGKPTC
DHL QUD