Manualshelf

WAN Subsystem Configuration and Management Manual

ManualsBrandsHP ManualsServerHP NonStop G-Series
919293949596979899100
Changing the Initial WAN Subsystem Configuration
WAN Subsystem Configuration and Management Manual—522463-011
3-9
Ethernet Port Reconfiguration Example
.
4. Reconfigure the ADAPTER object for the SWAN concentrator to use the new
E4SA, FESA, GESA, or G4SA port. Example 3-10 shows the commands used to
stop, alter, and restart the adapter object. This example alters Ethernet port B to
use the TCP/IP process that supports the selected port on the new adapter.
The WAN manager process automatically configures and automatically reconfigures (if
necessary) the SNMP trap multiplexer, TFTP server, and WANBoot processes
whenever an adapter object is added or altered with a new SUBNET configuration. An
additional optional attribute HOSTIP is provided to configure the WANBoot, TFTP, and
Example 3-9. TCP/IP Subsystem SCF INFO ROUTE and SUBNET Command
23-> info route $ztc1.*
TCP/IP Info ROUTE \IDC14.$ZTC1.*
Name Subnetname Destination Gateway Type
#GW #SN1 0.0.0.0 192.168.10.1 G
#RT2 #SN1 192.168.10.0 192.168.10.3
#RT1 #LOOP0 127.0.0.1 127.0.0.1 H
17-> info subnet $ztc*.*
TCP/IP Info SUBNET \MYSYS.$ZTC0.*
Name Devicename *IPADDRESS TYPE *SUBNETMASK SuName QIO *R
#LOOP0 \NOSYS.$NOIOP 127.0.0.1 LOOP-BACK %HFF000000 OFF N
#SN1 \MYSYS.L11123A 172.16.40.64 ETHERNET %HFFFFFF00 ON N
TCP/IP Info SUBNET \MYSYS.$ZTC1.*
Name Devicename *IPADDRESS TYPE *SUBNETMASK SuName QIO *R
#LOOP0 \NOSYS.$NOIOP 127.0.0.1 LOOP-BACK %HFF000000 OFF N
#SN1 \MYSYS.L11123B 172.16.40.65 ETHERNET %HFFFFFF00 ON N
TCP/IP Info SUBNET \MYSYS.$ZTC3.*
Name Devicename *IPADDRESS TYPE *SUBNETMASK SuName QIO *R
#LOOP0 \NOSYS.$NOIOP 127.0.0.1 LOOP-BACK %HFF000000 OFF N
#SN01 \MYSYS.L11123C 172.16.35.69 ETHERNET %HFFFFFF00 ON N
TCP/IP Info SUBNET \MYSYS.$ZTC4.*
Name Devicename *IPADDRESS TYPE *SUBNETMASK SuName QIO *R
#LOOP0 \NOSYS.$NOIOP 127.0.0.1 LOOP-BACK %HFF000000 OFF N
#SN1 \MYSYS.L11123D 172.16.45.69 ETHERNET %HFFFFFF00 ON N
Example 3-10. Stopping, Altering, and Restarting an ADAPTER Object
STOP ADAPTER $ZZWAN.#S01
ALTER ADAPTER $ZZWAN.#S01, &
ALTTCPIP $ZTC1, ALTHOSTIP 172.16.40.64
START ADAPTER $ZZWAN.#S01, SUB ALL