X25AM Configuration and Management Manual

SCF Commands for the X25AM Subsystem
X25AM Configuration and Management Manual—523424-004
4-29
Examples of the INFO Command
The format of the display for the INFO SU command with the DETAIL option is given
below. An asterisk in the display denotes an alterable attribute. The attributes are listed
alphabetically in Section 5, Attribute Descriptions.
Blank fields in the display above indicate either that they were never set or that they
have been reset.
Examples of the INFO Command
The following command gives you information about the line named $X25P1:
-> INFO LINE $x25p1
The following command gives you detailed information about the line named $X25P1:
-> INFO LINE $x25p1,DETAIL
The following command gives you information about the subdevice named
$X25P1.#TERM:
-> INFO SU $x25p1.#term
The following command gives you detailed information about the subdevice named
$X25P1.#TERM:
-> INFO SU $x25p1.#term,DETAIL
The following command gives you information about the subdevices named
$X25P1.#term1 and $X25P1.#term2:
-> ASSUME LINE $x25p1
-> INFO SU (#term1, #term2)
X25AM Detail Info SU $X25P1.#TERM
*AcceptChg.... OFF *DevType.... ( 6,0 ) *Recsize.......... 80
*PVC.......... *Parity..... NONE *Pricall.......... OFF
*Port......... 0 *Protocol... ITI *ParityChk........ OFF
*RexmitTimeout 0:20.00 *ReverseChg. OFF *Thruput.......... ( 4,4 )
*CUG.......... *Nullfill... OFF *RemoteNet........ X25XA
*CUGType...... BASIC *BCUG....... *Transitdelay.....
*DestAddr..... *LocalAddrExtType. 0
*Negotiate.... *RemoteAddrExtType 0
Associateline *Page6520BlkSize 256
*LocalAddrExt.
*RemoteAddrExt
*CUD..........
*RPOA..........125 , 300 , 5000
*Bpadparms....
*Cpadparms....