X25AM Configuration and Management Manual

SCF Commands for the X25AM Subsystem
X25AM Configuration and Management Manual—523424-004
4-42
Examples of the STATS Command
Sampletime
is the current date and time.
CircuitNum
is the circuit number associated with this SU object.
MsgSends
is the current count of messages sent on this circuit.
MsgReceives
is the current count of messages received on this circuit.
Examples of the STATS Command
The following command shows statistics for the subdevice named $X25P1.#TERM:
-> STATS SU $x25p1.#TERM
The following command shows statistics for the line named $X25P1:
-> STATS LINE $x25p1
Considerations for the STATS Command
•
X25AM does not support the SEL option.
•
X25AM supports the SUB option only for the LINE object type.
STATUS Command
The STATUS command displays information about the current state of lines and
subdevices, such as the dynamic state, the last error, and modifiable values of the
specified object. It also displays specific subsystem attributes and values. This is a
nonsensitive command.
Note. Version mismatches between X25AM and SCF may cause errors for the STATUS LINE
and STATUS SU commands under certain conditions.
To issue the STATUS command, first you need the name of the line or subdevice. To find the
names of your X25AM lines, enter LISTDEV TYPE 61 at the SCF prompt. TYPE 61 refers to
X25AM. The X25AM lines are listed in the “Names” column. To get the names of the
subdevices, enter NAMES LINE $linename, SUB.