X25AM Configuration and Management Manual

SCF Commands for the X25AM Subsystem
X25AM Configuration and Management Manual—523424-004
4-46
Display for the STATUS SU Command
PPIN
indicates the CPU and PIN of the primary X25AM I/O process.
Preferred IP
indicates the preferred IP address used by the process.
State
indicates the current summary state of the LINE object.
Subtype
is the subtype of the X25AM line. Only subtype 63 is allowed.
PriTrace
shows whether trace is turned on or off for the primary process.
Track ID
indicates the unique hardware identification of the SWAN concentrator (adapter).
Type
is the type of the X25AM line. Only type 61 is allowed.
Display for the STATUS SU Command
The display for the STATUS SU command has the following format (The X25AM
subsystem does not support the DETAIL option.):
Name
is the name of the SU object.
State
is the current summary state of the SU object.
DevType
shows the device type and subtype for the SU. The device type depends on the
protocol. The subtype depends on the protocol and terminal. Table 4-6 describes
the possible types and subtypes:
X25AM STATUS SU
Name State DevType Recsize SUnum Port LCNnum
$X25P1.#TERM STARTED 6,0 80 2 0