X25AM Configuration and Management Manual

Attribute Descriptions

X25AM Configuration and Management Manual—523424-004

5-2

BCUG

specifies the bilateral closed user group (BCUG) ID. The value must be in the range 0

through 9999. RESET means to delete any existing BCUG attribute. The default is no

BCUG ID.

BPADPARMS

specifies the block-mode X.3 PAD parameters. The value must be specified as pairs of

integers (the parameter number and its value). This attribute is valid only if the

PROTOCOL attribute value is ITI. If you do not specify BPADPARMS, SCF uses the

line’s BPADPARMS. If the line's BPADPARMS are not specified either, then X25AM

uses the standard PADPARMS according to the NETID. RESET means to delete all

existing BPADPARMS assignments. No BPADPARMS value is assigned by default.

CALLINGADDR

causes the X25AM subsystem to send either an SRCADDR or a null calling address in

outgoing call request packets. Off means send a null address. Use a null address with

networks that fill in the DTE address when the DTE transmits a call request with a null

calling address. On means send SRCADDR as the calling address.

Default: Not applicable

Range: 0 through 9999

Objects: Subdevices

Default: Any existing PADPARMS.

Range: For a list of parameters supported by ITI, see the X25AM

Programming Manual. For descriptions of standard PAD

profiles, see Appendix D, Using the NETID Modifier.

Objects: Subdevices and lines.

Note. If you alter the BPADPARMS or CPADPARMS and you have several pairs of parameters

already configured, you must enter all the pairs or they are reset. For example, if your

configuration has the pairs of parameters (1,1 2,15 4,0 13,0) and you want to alter 13,0 to 13,4,

you must enter all the other pairs of parameters.

Default: On

Range: On or Off

Objects: Lines