X25AM Configuration and Management Manual

Attribute Descriptions
X25AM Configuration and Management Manual—523424-004
5-5
DDNPREC
If you omit CUGTYPE and CUG is less than 99, the CUGTYPE default value is BASIC.
If you omit CUGTYPE and CUG is greater than 99, the CUGTYPE default value is EXT.
When you select RESET for the CUG attribute, CUGTYPE reverts to its default value
(BASIC).
DDNPREC
specifies the priority or the precedence negotiated by an X.25 DTE.
The attribute setting for a subdevice overrides the setting for a line. RESET causes the
attribute to be deleted from the SU or LINE (not set).
This attribute is displayed by issuing the INFO DETAIL command; a setting of -1
indicates the attribute is not set (or reset).
DDNSERVICE
specifies the type of service for a DDN network. The feature is a non-ITU-T facility.
Basic service provides end-to-end call management as described in the ITU-T
Recommendation X.25. Standard service provides support for acknowledgement from
the local DTE to the local DCE.
The attribute setting for a subdevice overrides the setting for a line. To display this
attribute, use the INFO DETAIL command.
DESTADDR
specifies the network address of the remote device that the subdevice uses as the
called address in outgoing call request packets. address is a string of decimal digits
(0 through 9) up to 15 digits long. RESET means to delete any existing DESTADDR
assignment. No DESTADDR is assigned. DESTADDR must be passed in the program
Default: BASIC
Range: BASIC, BASICOA, EXT, or EXTOA
Objects: Lines and Subdevices
Default: Not set
Range: 0 (lowest priority) through 3 (highest priority)
Objects: Lines and subdevices
Default: BASIC
Range: BASIC, STANDARD
Objects: Lines and subdevices