X25AM Configuration and Management Manual

Attribute Descriptions
X25AM Configuration and Management Manual—523424-004
5-6
DEVTYPE
using SETPARAM or CALL^REQ in PTP mode 2. If no DESTADDR is present, the
packet is sent with a called address length of zero (0).
DEVTYPE
specifies the device type and subtype for an SU. The device type depends on the
protocol you use. The subtype depends on the protocol and the terminal. DEVTYPE is
a required attribute for the ADD SU command.
Table 5-1 describes the possible DEVTYPES; the first integer is the type, the second is
the subtype.
DSRTIMEOUT
specifies the time interval that the CLIP waits to receive the data set ready (DSR)
signal from the modem. The value must in the range 0 through 5:27:67.
Default: None
Range: String of decimal digits (0 through 9) up to 15 digits long
Objects: Subdevices
Default: Not applicable
Range: Refer to Table 5-1
Objects: Subdevices
Note. DEVTYPE differs from the TYPE and SUBTYPE (ADD DEVICE modifiers) specified for
an X25AM I/O process. The TYPE of an X25AM I/O process must always be 61. The
SUBTYPE of an X25AM I/O process must always be 63.
Table 5-1. DEVTYPE for an SU
6,0 ITI Conversational-mode terminal
6,1 6510 (ADM-2) terminal
6,2 6520 (ZENTEC) terminal
6,4 6530 terminal
9,0 PTP Not applicable
58,20 QLLC Not applicable
63,0 NAM Not applicable
Default: 20 seconds
Range: 0 through 5:27:67
Objects: Lines