X25AM Configuration and Management Manual

Attribute Descriptions
X25AM Configuration and Management Manual—523424-004
5-7
EMSFORFRMR
EMSFORFRMR
displays an EMS message when a link reset occurs due to a Frame Reject (FRMR)
condition on an X25AM line. The modifier accepts values in the range 0 to 200. By
default, this feature is disabled.
Configure this modifier with a non-zero value to enable generation of an EMS message
during an FRMR condition.
If this Modifier is set to:
An FRMR condition occurs when an illegal frame is received on an X25AM line which
results in a X25AM link and line reset.
EXTFORMAT and NOEXTFORMAT
switches on or off the reception of larger-than-normal packets using the
fast-select feature. To turn on this feature using the ALTER LINE command, the
PACKETSIZE modifier must be 256 bytes or larger.
FRAMEMODE
specifies either a DTE or DCE station. In a point-to-point configuration, such as in
X.25, one side must be a DCE and the other side must be a DTE; otherwise, error 171
occurs and the link state never goes to the READY state.
Default: Zero
Range: 0 to 200
Objects: Lines
0 Disables the generation of an EMS message during link reset due to an
FRMR condition.
1 Generates an EMS message for every FRMR which causes the X25AM link
reset.
2-200 Enables generation of EMS messages and controls the frequency at which
they are generated.
For example, if EMSFORFRMR is set to 10, an EMS message is generated
on every tenth link reset caused by an FRMR condition.
Default: Off (EXTFORMAT not set)
Range: On or Off
Objects: Lines
Default: DTE
Range: DTE or DCE
Objects: Lines