X25AM Configuration and Management Manual

Attribute Descriptions
X25AM Configuration and Management Manual—523424-004
5-12
PORT
PORT
specifies the logical port number to be used by the subdevice. This value must be in
the range 0 through 9999. The default is zero (0). The range for the port is defined by
the NETID.
PRICALL
specifies whether you can make priority calls. This modifier is only applicable if NETID
is DATAPAC. If off, outgoing calls do not include the DATAPAC national parameter for
priority calls. To use PRICALL set to on, set NETID to DATAPAC.
PROGRAM
specifies the program that is to be downloaded to the CLIP. The X25AM I/O process
modifier, PROGRAM, specifies the program that downloads the microcode file to the
CLIP. Replace the default for PROGRAM only if you are:
•
Using a SWAN 2 concentrator (use modifier C1096Q00 instead)
•
Implementing an X.21 interface that has an X.21 converter cable (for SWAN
concentrator (T3880), use modifier C0051P00; for a SWAN 2 concentrator, use
modifier C0051Q00).
PROTOCOL
specifies the protocol that the subdevice uses. The protocol can be ITI, NAM, PTP, or
QLLC. PROTOCOL is a required attribute for the ADD SU command.
Table 5-2 on page 5-13 shows the X25AM protocols and their uses.
Default: Zero (0)
Range: 0 through 9999
Objects: Subdevices
Default: Off
Range: On or Off
Objects: Subdevices
Default: C1096P00
Range: C1096P00, C0051P00, C1096Q00, or C0051Q00
Objects: Lines
Default: None
Range: ITI, NAM, PTP, or QLLC
Objects: Subdevices