X25AM Configuration and Management Manual

Attribute Descriptions

X25AM Configuration and Management Manual—523424-004

5-15

RETRIES

specifies the number of frame-layer (level-2) retries (N2) executed (that is, commands

sent without receiving a response) before a link is considered to be disconnected and

is reset (all counters are set to 0). This value must be in the range 0 through 255.

REVERSECHG

specifies whether an outgoing call request will request that the recipient pay the

charges. On indicates that the recipient will be requested to pay the charges. The

default value is Off.

REXMITTIMEOUT

specifies the time interval within which an ITI block-mode terminal must respond. This

value must be in the range 0 through 5:27:67. The default value is 20 seconds.

RPOA

specifies the Registered Private Operating Agency (RPOA) transit network (or

networks) to be configured on the LINE object. You identify an RPOA transit network

with a data network identification code (DNIC) in the range 0 through 9999. If you

specify more than one DNIC, the DNIC entries must be separated by commas and

enclosed in parentheses. The maximum number of DNIC values that you can specify is

Default: 10

Range: 0 through 255

Objects: Lines

Default: Off

Range: On or Off

Objects: Subdevices

Caution. The value of the REXMITTIMEOUT attribute for SUs is not displayed as it is entered.

It is rounded down to the nearest 5-second interval.

Default: 20 seconds

Range: 0 through 5:27:67

Objects: Subdevices