X25AM Configuration and Management Manual

Attribute Descriptions
X25AM Configuration and Management Manual—523424-004
5-16
SRCADDR
7. RESET means to delete any existing RPOA attribute. No RPOA is assigned by
default.
SRCADDR
specifies the X25AM network address for your system. The address is a string of
decimal digits (0 through 9) up to 15 digits long. RESET deletes any existing
SRCADDR assignment. SRCADDR specifies either the calling address used in a
currently connected call or an address defined by SCF.
SVCRANGE
specifies the range of logical channels to use for switched virtual circuits (SVCs). The
number of circuits is defined by the CIRCUITS modifier. Each integer of the pair must
have a value in the range 1 through 4095, except for TRANSPAC, in which the range is
0 through 4095. The first integer must be greater than the highest value specified for
the modifier PVCRANGE. The second integer must be greater than the first integer
and less than 4096. If you omit the second integer, X25AM calculates the upper bound
based upon the circuits available. RESET means to delete any existing SVCRANGE
assignment.
Although 1 through 4095 is the range for the possible number of circuits, you cannot
effectively use 4095 circuits because the actual usable number is the number of
circuits to which you subscribe. This includes the total of permanent virtual circuits
(PVCs) plus switched virtual circuits (SVCs).
The actual range of circuits allowable is 1 through 510.
SYNCS
This attribute is not supported for systems running G-series RVUs.
Default: None.
Range: DNIC codes range from 0 through 9999. Maximum number of
DNIC values is 7.
Objects: Lines and subdevices.
Default: None
Range: A string of decimal digits (0 through 9) up to 15 digits long
Objects: Lines
Default: 1 to the number of allowable circuits (depending on the RVU)
Range: 1 through 4095
Objects: Lines