X25AM Configuration and Management Manual

ManualsBrandsHP ManualsServerHP NonStop G-Series

161

162

163

164

165

166

167

168

169

170

PTrace for the X25AM Subsystem

X25AM Configuration and Management Manual—523424-004

6-20

Sample Trace Reading of Calls Being Cleared

5. Check the port number of the subdevice to make sure it has been correctly

configured:

6. The display from the INFO SU command reveals the problem. Because there is no

port number 4, level 3 is clearing the call. Alter the port number to correspond to

the incoming call request, and the call should then be accepted. Use the following

commands to alter the port number for the subdevice named #PTP:

-> ABORT SU #PTP

-> ALTER SU #PTP,PORT 4

-> START SU #PTP

Check that the subdevice has been correctly altered:

7. Try the call again after you have changed the port number. Use the following

command to start the trace:

-> TRACE,TO TRX3,SELECT L3

-> info su $x25p1.#ptp, detail

X25AM Detail Info SU $X25P1.#PTP

*AcceptChg.... OFF *DevType.... ( 9,0 ) *Recsize.......... 128

*PVC.......... *Parity..... NONE *Pricall.......... OFF

*Port......... 3 *Protocol... PTP *ParityChk........ OFF

*RexmitTimeout 0:20.00 *ReverseChg. OFF *Thruput.......... ( 4,12)

*CUG.......... *Nullfill... OFF *RemoteNet........ X25XA

*CUGType...... BASIC *BCUG....... *Transitdelay.....

*DestAddr..... *LocalAddrExtType. 0

*Negotiate.... *RemoteAddrExtType 0

Associateline *Page6520BlkSize 0

*LocalAddrExt.

*RemoteAddrExt

*CUD..........

*RPOA..........

*Bpadparms....

*Cpadparms....

Note. For port digits using X25 NETID, the port number is right justified with a padding 0, so

port 4 = 04.