X25AM Configuration and Management Manual

X25AM Configuration and Management Manual—523424-004
C-1
C X25AM Error Messages
This appendix describes network-related operator console error messages and
common file-system error messages. Cause and recovery information for each error
message is included.
This appendix only includes messages issued by the X25AM subsystem. The user can
receive, through SCF, error messages generated by the file system, SCP, and so on.
File-system, SCP, and other errors originating outside the SCF environment are
described in the documentation supporting the particular source of the error and are
not described here. Depending on your RVU, the SCF Reference Manual for G-Series
RVUs or the SCF Reference Manual for H-Series RVUs lists SCF error messages that
are common to all data communications subsystems. Table C-1 lists the formats of the
error message numbers and directs you to where you can find more information about
them.
You can also get information about error messages by using the SCF HELP command
(for example, by typing HELP X25AM 501). For more information about online help,
see the SCF Reference Manual for G-Series RVUs or SCF Reference Manual for
H-Series RVUs.
Message Descriptions
The X25AM error messages are listed by message number, from lowest to highest.
00500
Cause. An attribute has been entered twice in the command.
Effect. Command is not executed.
Recovery. Remove the duplicate attribute, and reissue the command.
Table C-1. Sources and Documentation of X25AM Error Messages
Number Generated By Manual
-nnnnn SCP
•
SCF Reference Manual for G-Series RVUs
•
SCF Reference Manual for H-Series RVUs
005nn X25AM subsystem this manual
20nnn SCF
•
SCF Reference Manual for G-Series RVUs
•
SCF Reference Manual for H-Series RVUs
X25AM E00500 Duplicate Attribute