X25AM Configuration and Management Manual

X25AM Error Messages
X25AM Configuration and Management Manual—523424-004
C-3
00507
00507
Cause. The value entered for the named attribute on the specified object name is not
valid.
Effect. Command is not executed.
Recovery. Check the valid values for this attribute, and reissue the command with a
valid value.
00509
Cause. The number of values given to this attribute exceeds the limit.
Effect. Command is not executed.
Recovery. Make sure the number of values given does not exceed the limit allowed
for this attribute, and re-issue the command.
00510
Cause. The subdevice is open. The STOP command is rejected if it is issued against
an open subdevice or against a line with an open subdevice.
Effect. Command is not executed.
Recovery. Use the ABORT command or close the subdevice, and reissue the STOP
command.
00511
Cause. The named attributes are inconsistent.
Effect. Command is not executed.
Recovery. Check for the proper attributes, and reissue the command.
X25AM E00507 Invalid Value: attribute-name for Object name
X25AM E00509 Too many values given
X25AM E00510 STOP command is not completed because the
subdevice is open
X25AM E00511 attribute-name and attribute-name are
inconsistent