X25AM Configuration and Management Manual

Using the NETID Modifier
X25AM Configuration and Management Manual—523424-004
D-5
Detail-Set Specifications
Table D-7. DATAPAC
Call Addressing: SU PORT NUMBER is from 0 to 99.
Incoming Call: Uses the fifth byte of the call user data as the called port number. Port
number 0 is the default.
Call Request: If both LINE NETID and SU REMOTENET are DATAPAC, then called
address is SU DESTADDR.
If only SU REMOTNET is DATAPAC, then called address is SU
DESTADDR minus the last two digits. The last two digits plus%H40
are placed in the fifth byte of the call user data field (01 =%H41, 02
=%H42, and so on).
Calling address is LINE SRCADDR.
PAD Profile: Standard default.
Linefeed Echo: Performed by PAD.
Editing: Performed by PAD.
Parameters: Special and national.
Other: Turns on 1980 format priority calls.
Table D-8. DATEX-P
Call Addressing: Defined by the network.
PAD Profile: Standard default.
Linefeed Echo: Performed by PAD.
Editing: X25AM I/O process performs.
Parameters: Special profile.
Other: Call accept packet does not include address and facilities lengths
fields when EXTENDEDFORMAT is OFF.
Table D-9. DDN (Like X25)
Call Addressing: SU PORT NUMBER is 0 to 99 digits; leading zeros are included.
Incoming Call: Called address is LINE SRCADDR + SU PORT NUMBER.
A 0- to 2-digit port number is expected.
Call Request: Called address is SU DESTADDR.
Calling address is LINE SRCADDR + SU PORT NUMBER.
PAD Profile: Standard default.
Linefeed Echo: X25AM I/O process performs.
Editing: X25AM I/O process performs.