X25AM Configuration and Management Manual

Using the NETID Modifier
X25AM Configuration and Management Manual—523424-004
D-8
PAD Profiles
PAD Profiles
The two notes below apply to all of the PAD profile tables:
Standard PAD Profiles
Table D-17, Table D-18 on page D-9, and Table D-19 on page D-10 provide
descriptions of the standard PAD profiles.
Conversational Mode
Table D-16. UNINET (Like X25UD)
Call Addressing: SU PORT NUMBER is from 0 to 99.
Incoming Call: Called address is LINE SRCADDR + SU PORT NUMBER. The port
number is the fifth byte of call user data. The default is 0.
Call Request: Called address is SU DESTADDR minus its last digits. The last two
digits plus %H40 are placed in the fifth byte of the call user data field
(01 = %H41, 02 = %H42, and so on).
Calling address is LINE SRCADDR.
PAD Profile: Standard default.
Linefeed Echo: Performed by PAD.
Editing: X25AM I/O process performs.
(*) This is a configurable parameter. The parameter value depends on the
configuration of the subdevice.
(***) The PAD parameter separator is used to differentiate between the
standard X.3 parameters and the network-specific parameters.
Parameters preceding the national options marker are standard X.3
parameters. Parameters following the parameter separator are network-
specific parameters used and defined only for that particular network.
Table D-17. Standard PAD Profiles for Conversational Mode (page 1 of 2)
X.3 Parameter
Internal Parameter
Code,Value
Actual Parameter
Code,Value
Escape to command mode 1,1 1,1
Echo 2,0 2,0 or 1 (*)
Selection of data-forwarding conditions 3,126 3,2 or 126 (*)
Idle timer 4,0 4,0
Break handling 7,21 7,0 or 21 (*)