X25AM Configuration and Management Manual

Configuration Files for the X25AM Subsystem
X25AM Configuration and Management Manual—523424-004
G-3
Starting X25AM Lines
The STATUS commands result in the following displays:
Starting X25AM Lines
After starting the X25AM I/O processes, you start the X25AM lines that are controlled
by the I/O processes (in this example, $ZZWAN.#X25P1 and $ZZWAN.#X25S1). The
following example is an SCF command file for starting both X.25 lines.
The STATUS commands result in the following displays:
WAN Manager STATUS DEVICE for DEVICE \TOYS2.$ZZWAN.#X25P1
State :......... STARTED
LDEV number..... 156
PPIN............ 0 ,297 BPIN............ 1 ,270
WAN Manager STATUS DEVICE for DEVICE \TOYS2.$ZZWAN.#X25S1
State :......... STARTED
LDEV number..... 146
PPIN............ 0 ,277 BPIN............ 1 ,302
START LINE $x25p1
START LINE $x25s1
STATUS LINE $x25p1, DETAIL
STATUS LINE $x25s1, DETAIL
X25AM Detail Status Line $X25P1
Preferred IP....... 192.168.005.084 Alternate IP...... 192.168.007.084
Track ID.... X017JJ CMG........ $ZZW00 I/O ADDR.. ( 0,4,3,0)
State....... STARTED PPIN....... ( 0,97) BPIN....... ( 1,70)
LinkState... READY LDEV....... 156 NumSU...... 0
InUse....... YES Circuits... 510 Path....... B
DCD......... ON DSR........ ON CTS........ ON
CMG LDev.... 151 Type....... 61 Sub-Type... 63
PriTrace.... OFF BkpTrace... OFF
X25AM Detail Status Line $X25S1
Preferred IP....... 192.168.005.084 Alternate IP...... 192.168.007.084
Track ID.... X017JJ CMG........ $ZZW00 I/O ADDR.. ( 0,4,3,1)
State....... STARTED PPIN....... ( 0,77) BPIN....... ( 1,2 )
LinkState... READY LDEV....... 146 NumSU...... 0
InUse....... NO Circuits... 510 Path....... A
DCD......... ON DSR........ ON CTS........ ON
CMG LDev.... 151 Type....... 61 Sub-Type... 63
PriTrace.... OFF BkpTrace... OFF