X25AM Configuration and Management Manual

Configuration Files for the X25AM Subsystem
X25AM Configuration and Management Manual—523424-004
G-4
Adding Subdevices to an X25AM Line
Adding Subdevices to an X25AM Line
After starting an X25AM line, you can configure its associated subdevices. Subdevices
are started automatically when you add them. The following SCF command file adds
two subdevices to the $X25P1 line.
The STATUS and INFO commands for $X25P1.#TERM result in the following displays:
ADD SU $x25p1.#term, PROTOCOL ITI, DEVTYPE (6,0), &
RECSIZE 80, RPOA (125, 300, 5000)
STATUS SU $x25p1.#term
INFO SU $x25p1.#term, DETAIL
ADD SU $x25p1.#term1, PROTOCOL PTP, DEVTYPE (9,0), &
RECSIZE 80, RPOA (125, 300, 5000)
STATUS SU $x25p1.#term1
INFO SU $x25p1.#term1, DETAIL
X25AM STATUS SU
Name State DevType Recsize SUnum Port LCNnum
$X25P1.#TERM STARTED 6,0 80 2 0
X25AM Detail Info SU $X25P1.#TERM
*AcceptChg.... OFF *DevType.... ( 6,0 ) *Recsize.......... 80
*PVC.......... *Parity..... NONE *Pricall.......... OFF
*Port......... 0 *Protocol... ITI *ParityChk........ OFF
*RexmitTimeout 0:20.00 *ReverseChg. OFF *Thruput.......... ( 4,4 )
*CUG.......... *Nullfill... OFF *RemoteNet........ X25XA
*CUGType...... BASIC *BCUG....... *Transitdelay.....
*DestAddr..... *LocalAddrExtType. 0
*Negotiate.... *RemoteAddrExtType 0
Associateline *Page6520BlkSize 256
*LocalAddrExt.
*RemoteAddrExt
*CUD..........
*RPOA..........125 , 300 , 5000
*Bpadparms....
*Cpadparms....