Manualshelf

X25AM Configuration and Management Manual

ManualsBrandsHP ManualsServerHP NonStop G-Series
21222324252627282930
X25AM Configuration and Management Manual—523424-004
1-1
1 Configuration Quick Start
This section is a configuration quick start for the ServerNet X25AM subsystem. This
procedure explains how to set up the initial X25AM processes on an
Integrity NonStop NS-series or NonStop S-series server.
To help you complete the configuration tasks quickly, this section recommends you
accept the default values provided by the X25AM subsystem. If you want to change
your X25AM configuration, or if you want to complete the initial configuration without
using the default configuration values, refer to the appropriate sections of this manual.
Task Summary
1. Log On to the NonStop Server and Obtain SWAN/SWAN 2 Information on
page 1-2
2. Add the X25AM Profile on page 1-4
3. Add the X25AM I/O Processes on page 1-5
4. Start the X25AM I/O Processes and Lines on page 1-6
5. Add X25AM Subdevices on page 1-7
Assumptions
At the beginning of the procedure, the Integrity NonStop NS-series or
NonStop S-series server is in the following state:
•
The default software configuration is as shipped by manufacturing.
•
The initial TSM or OSM configuration is complete. Note that TSM is not supported
on Integrity NonStop NS-series servers.
•
The ServerNet LAN Systems Access (SLSA) subsystem has been defined and
started. Also, a LAN adapter (for example, a Gigabit Ethernet 4-port ServerNet
adapter (G4SA) has been installed and started). Note that the G4SA can only be
installed in an I/O Adapter Module (IOAM) enclosure. For more information, see
the Gigabit Ethernet 4-Port Adapter Installation and Support Guide.
•
A NonStop TCP/IP process has been defined and started. Note that
NonStop Parallel Library TCP/IP is not supported on Integrity NonStop NS-series
servers.
•
The WAN manager process ($ZZWAN) has been defined and started.
•
The WAN processes CONMGR process is defined and started. The WANBOOT,
TFTP, and SNMP are automatically started.
•
The SWAN/SWAN 2 concentrator has been installed, defined and started and has
an available WAN line.