X25AM Configuration and Management Manual

Configuration Quick Start
X25AM Configuration and Management Manual—523424-004
1-2
Log On to the NonStop Server and Obtain
SWAN/SWAN 2 Information
•
Use the FILEINFO command to verify that you have the following X25AM files:
°
$SYSTEM.SYSnn.X25OBJ
°
$SYSTEM.SYSnn.PX250061
°
$SYSTEM.CSSnn.C1096P00 or $SYSTEM.CSSnn.C0051P00 (for T3880
SWAN concentrator) or $SYSTEM.CSSnn.C1096Q00 or
$SYSTEM.CSSnn.C0051Q00 (for T3881 SWAN 2 concentrator)
You need C0051P00 or C0051Q00 only if you are implementing an X.21 interface
on a SWAN/SWAN 2 concentrator that has an X.21 converter cable.
Log On to the NonStop Server and Obtain
SWAN/SWAN 2 Information
1. Log on to the NonStop NS-series or NonStop S-series server using the Super ID,
and enter the correct password at the Password: prompt.
> LOGON super.super
Password:
2. At the TACL prompt on the NonStop NS-series or NonStop S-series server, start
SCF.
> SCF
3. Determine the names of the SWAN/SWAN 2 concentrators on the system.
-> NAMES ADAPTER $ZZWAN.#*
4. Determine where an available WAN line exists on one of the SWAN/SWAN 2
concentrators (for example, S01). The STATUS SERVER command lists the fields
you need when issuing the ADD DEVICE command; in the following example only
the display for the CLIP with available lines is shown.
-> STATUS SERVER $ZZWAN.#s01.*
a. Record the name of the SWAN/SWAN 2 concentrator
(\system.$zzwan.#conc-name) in the adapter field in Table 1-1,
Worksheet for Adding an X25AM I/O Process, on page 1-5.
ADAPTER
$ZZWAN.#S02
$ZZWAN.#S01
WAN Manager STATUS SERVER for CLIP \TOYS2.$ZZWAN.#S01.3
State :......... STARTED
Path A..........: CONFIGURED
Path B..........: CONFIGURED
Number of lines. 2
Line............ 0 : FREE
Line............ 1 : FREE