X25AM Configuration and Management Manual

Configuration Quick Start
X25AM Configuration and Management Manual—523424-004
1-6
Start the X25AM I/O Processes and Lines
.
Repeat Add the X25AM I/O Processes on page 1-5 for each X25AM line you need to
configure.
For additional information about ADD DEVICE modifiers and values, see the WAN
Subsystem Configuration and Management Manual. For information about ADD
DEVICE modifiers that are specific to X25AM I/O processes, see the X25AM Modifier
Dictionary on page 3-15.
Start the X25AM I/O Processes and Lines
1. After adding the X25AM profile and I/O processes, issue the SCF START
command to the WAN subsystem to start each I/O process. For example:
-> START DEVICE $ZZWAN.#x25p1
Issue the STATUS DEVICE command to make sure the device has been started.
2. After the I/O process has been started, you start the line that it controls using the
SCF START LINE command to the X25AM subsystem. For example:
-> START LINE $x25p1
Issue the STATUS LINE command to make sure the line has been started.
Repeat Steps 1 and 2 for each X25AM I/O process you have added.
For information about the SCF START DEVICE command, see the WAN Subsystem
Configuration and Management Manual. For information about the START LINE
command, see START Command on page 4-33.
Example 1-1. Syntax to Create an X25AM I/O Process
-> ADD DEVICE $ZZWAN.#x25p1, PROFILE PX250061, &
-> IOPOBJECT $SYSTEM.SYS00.X25OBJ, &
-> PROGRAM $SYSTEM.CSS00.C1096P00, &
-> TYPE (61,63), &
-> RECSIZE 32767, &
-> ADAPTER ___S01______, & (See Step 4a)
-> CLIP ______3______, & (See Step 4b)
-> LINE ______1______, & (See Step 4c)
-> PATH ______A______, & (See Step 4d)
-> CPU _______0___, & (See Step 5c)
-> ALTCPU ____1______ & (See Step 5c)
Replace C1096P00 with C0051P00 if you are implementing an X.21 interface with an X.21 converter cable.