X25AM Configuration and Management Manual

Configuring an X25AM Subsystem
X25AM Configuration and Management Manual—523424-004
3-3
Configuration Tasks
The SCF commands to the WAN subsystem that are relevant to X25AM configuration
are described in this section. The WAN subsystem and the SCF commands to the
WAN subsystem are described in the WAN Subsystem Configuration and Management
Manual.
Configuration Tasks
To configure the X25AM subsystem, perform the following tasks:
1. Review configuration prerequisites
2. Familiarize Yourself with Subsystems, Commands, and Attributes
3. Add the X25AM profile
4. Determine the configuration information for the SWAN concentrator
5. Add the X25AM I/O processes (one for each line)
6. Start the X25AM I/O processes
7. Start the X25AM lines
8. Add the X25AM subdevices
Task 1: Review Configuration Prerequisites
You need the following:
•
Either an Integrity NonStop NS-series server using a Gigabit Ethernet 4-port
ServerNet adapter (G4SA) in an IOAM enclosure or a NonStop S-series server
using a Ethernet 4 ServerNet adapter (E4SA), Fast Ethernet ServerNet Adapter
(FESA), or Gigabit Ethernet ServerNet adapter (GESA).
•
NonStop operating system (G06.07 or later) installed on your system with the
latest WAN module software and correct version procedures (VPROCs). To use a
G4SA, your NonStop operating system must be G06.24 or later.
•
The WAN subsystem must be started before you attempt to configure the X25AM
subsystem.
°
The TCP/IP, LANMON, and TFTP processes running.
°
The WANMGR process running.
°
The WAN components WANBOOT and CONMGR running.
If any of these components is missing, see the WAN Subsystem Configuration and
Management Manual for complete instructions on how to add them.