X25AM Configuration and Management Manual

Configuring an X25AM Subsystem
X25AM Configuration and Management Manual—523424-004
3-6
Task 4: Determine the SWAN Configuration
Information
For detailed information about using the ADD PROFILE command, see the WAN
Subsystem Configuration and Management Manual.
Task 4: Determine the SWAN Configuration Information
Before you add any X25AM I/O process, verify that all the WAN subsystem processes,
profiles, and the SWAN concentrator have been added and started.
To add an X25AM I/O process, you need to know:
•
SWAN concentrator name
•
CLIP number with an available line
•
Line number on the CLIP that the I/O process will control
•
Processors in which the TCP/IP processes for the SWAN concentrator are running
Ensure you have the following X25AM files:
If you are implementing an X.21 line with an X.21 converter cable, make sure you have
either:
•
$SYSTEM.CSSnn.C0051P00 (for the SWAN concentrator T3880)
•
$SYSTEM.CSSnn.C0051Q00 (for the SWAN 2 concentrator T3881)
The following commands show how to determine this information:
1. Find a SWAN/SWAN 2 concentrator name:
-> NAMES ADAPTER $ZZWAN.#*
lists the names of all concentrators on the system.
2. Find a SWAN CLIP with available lines:
-> STATUS SERVER $ZZWAN.#conc-name.*
displays the status of all lines on all clips on the SWAN concentrator conc-name.
3. Find the processors in which the SWAN TCP/IP processes are running:
-> INFO ADAPTER $ZZWAN.#conc-name
displays the names of the TCP/IP processes.
-> STATUS PROCESS $tcpip-process-name
-> STATUS PROCESS $alt-tcpip-process-name
displays the PPID of each TCP/IP process.
For the SWAN Concentrator (T3880) For the SWAN 2 Concentrator (T3881)
$SYSTEM.SYSnn.X25OBJ $SYSTEM.SYSnn.X25OBJ
$SYSTEM.CSSnn.C1096P00 $SYSTEM.CSSnn.C1096Q00