X25AM Configuration and Management Manual

Configuring an X25AM Subsystem
X25AM Configuration and Management Manual—523424-004
3-8
Task 6: Start an X25AM I/O Process
Task 6: Start an X25AM I/O Process
After adding the X25AM profile and I/O processes, issue the SCF START command to
the WAN subsystem (see Figure 3-3 on page 3-8) to start each I/O process:
-> START DEVICE $ZZWAN.#io-process-name
Examples of using the SCF START command to start X25AM I/O processes are:
-> START DEVICE $ZZWAN.#X25P1
-> START DEVICE $ZZWAN.#X25S1
For detailed information about using the START DEVICE command, see the WAN
Subsystem Configuration and Management Manual.
Figure 3-2. Adding an X25AM I/O Process
Figure 3-3. Starting an X25AM I/O Process
VST0302.vsd
WAN
Subsystem
$ZZWAN
1. ADD DEVICE $ZZWAN.#X25P1
2. Create
object
Management
Information
Base (MIB)
DEVICE
Object
($ZZWAN.#X25P1)
VST0303.vsd
WAN
Subsystem
$ZZWAN
1. START DEVICE $ZZWAN.#X25P1
X25AM
Subsystem
X25AM
I/O Process
($X25P1)
3. Launch
process
2. Look up
parameters
Management
Information
Base (MIB)
DEVICE
Object
($ZZWAN.#X25P1)