X25AM Configuration and Management Manual
Configuring an X25AM Subsystem
X25AM Configuration and Management Manual—523424-004
3-10
Task 8: Add X25AM Subdevices
The format for the output of the STATUS LINE command with the DETAIL option is:
If a line is not in the STARTED READY state, check the following:
•
Framemode: If one side is DTE, the other side should be DCE.
•
If a line has been STARTED but is not READY, check the connection to the modem
and its related cables.
•
If the CLIP code cannot be downloaded (because the line is not going to a
STARTED state), check that you are using the correct version of the CLIP code.
•
Check that the TFTP process is running correctly.
Make any corrections and try the SCF START LINE command again.
If you have made all of the previous checks and attempts and only if the line does not
become STARTED, reset the SWAN/SWAN 2 concentrator and try the SCF START
LINE command again.
For more information about the SCF START LINE command and commands to
manage lines, see Section 4, SCF Commands for the X25AM Subsystem.
For examples of scripts and TACL macros, see the WAN Subsystem Configuration and
Management Manual.
Task 8: Add X25AM Subdevices
After starting an X25AM I/O process and its line, you can add the subdevices required
for the line by using SCF commands to the X25AM subsystem. To add an X25AM
subdevice, use the SCF ADD SU command. For example:
-> ADD SU $x25p1.#term, PROTOCOL ITI, DEVTYPE (6,0), &
-> RECSIZE 80, RPOA (125, 300, 5000)
The subdevice is started automatically. Another example:
-> ADD SU $x25p1.#term1, PROTOCOL PTP, DEVTYPE (9,0), &
-> RECSIZE 80, RPOA (125, 300, 5000)
The first three attributes, PROTOCOL, DEVTYPE, and RECSIZE, are required; all
other attributes are optional. PROTOCOL and DEVTYPE are related; for descriptions
of all subdevice attributes, see Section 5, Attribute Descriptions.
X25AM Detail Status Line $X25P1
Preferred IP....... 192.168.005.084 Alternate IP...... 192.168.007.084
Track ID.... X017JJ CMG........ $ZZW00 I/O ADDR.. ( 0,4,3,0)
State....... STARTED PPIN....... ( 0,3 ) BPIN....... ( 1,4 )
LinkState... READY LDEV....... 156 NumSU...... 0
InUse....... YES Circuits... 510 Path....... B
DCD......... ON DSR........ ON CTS........ ON
CMG LDev.... 151 Type....... 61 Sub-Type... 63
PriTrace.... OFF BkpTrace... OFF