X25AM Configuration and Management Manual

Configuring an X25AM Subsystem
X25AM Configuration and Management Manual—523424-004
3-18
Numeric Range Validation
DISABLEPVCOUTOFORDER.
See ENABLEPVCOUTOFORDER
DRTIMEOUT n
DRTIMEOUT is the driver (I/O) timer. This is the maximum time interval allowed for a
driver response before retrying a driver request.
DSRTIMER n
DSRTIMER is the time interval the SWAN/SWAN 2 concentrator waits to receive a
DATASET READY signal from the modem before returning a status message to the
X25AM I/O process.
The value can be altered with the SCF line attribute DSRTIMEOUT.
DTE
DTE and DCE control whether a line (that is, its I/O process) operates as a DTE or a
DCE. A line is usually configured as a DTE. You configure a line as a DCE for special
requirements (for example, loopback testing).
A DTE and a DCE have slightly different Link Layer addressing, Packet Layer LCN
selection, and call-collision processing (see Figure 3-6
on page 3-19).
This modifier can be altered with the SCF line attribute FRAMEMODE.
Default: 300 (3 seconds)
Value: .01 seconds
Range: 0 through 32767 (5 minutes, 27.67 seconds)
Default: 2000 (20 seconds)
Value: .01 seconds
Range: 0 through 32767 (5 minutes, 27.67 seconds)
Default: DTE
Units: Not applicable
Alternate Modifier: DCE