X25AM Configuration and Management Manual

Configuring an X25AM Subsystem
X25AM Configuration and Management Manual—523424-004
3-20
Numeric Range Validation
ENABLECALLEDADDREXT
ENABLECALLEDADDREXT specifies whether a Called Address Extension can be
sent if the previous Call Accept packet does not contain this facility.
•
If set, this modifier enables sending a Called Address Extension, even when the
previous Call Accept packet does not contain a Calling Address Extension.
•
If not set (or reset), a Called Address Extension is not sent if the previous Call
Accept packet does not contain the Calling Address Extension.
ENABLEPVCOUTOFORDER
ENABLEPVCOUTOFORDER or DISABLEPVCOUTOFORDER specifies whether or
not the console messages 225 and 226 are generated when a permanent virtual circuit
(PVC) is out of order.
•
ENABLEPVCOUTOFORDER: Generates console messages 225 and 226 for a
PVC that is out of order.
•
DISABLEPVCOUTOFORDER: Does not generate console messages 225 and
226. When an out-of-order PVC is a normal (frequent) occurrence, you might not
want to generate these messages.
EXTENDEDPOOLPAGES
EXTENDEDPOOLPAGES specifies the total amount of memory (in pages) needed for
all the circuits configured for the line.
Default: Not set
Units: Not applicable
Alternate Modifier None; use RESET ENABLECALLEDADDREX to reset this
modifier
Note: Only applies to Call Address Extension facility users
Default: ENABLEPVCOUTOFORDER
Units: Not applicable
Alternate Modifier: DISABLEPVCOUTOFORDER
Note: Only applies to PVC subdevices
Default: 50
Units: Pages (2048 bytes)
Range: 10 to 2047
Note. The EXTENDEDPOOLPAGES modifier replaces the LOCALPOOLPAGES modifier.
However, the LOCALPOOLPAGES value was calculated automatically by X25AM. You must
calculate a value for EXTENDEDPOOLPAGES.