X25AM Configuration and Management Manual

Configuring an X25AM Subsystem
X25AM Configuration and Management Manual—523424-004
3-24
Numeric Range Validation
L2IFRAMERECOVERY
L2IFRAMERECOVERY has no effect on the X25AM line handler process.
L2NODISC
L2DISC or L2NODISC specifies whether or not a DISC (disconnect) command is sent
when an X25AM I/O process wants to reset a link across a line.
When an X25AM I/O process wants to reset a link (all counters are set to zero and all
calls are cleared), the process issues Set Asynchronous Balanced Mode (SABM) or
disconnect (DISC) commands. If a response is not received, the process continues to
send either SABM or DISC commands.
If L2NODISC is specified, the process sends SABM commands.
If L2DISC is specified, the process sends DISC commands.
L2RETRIES n
L2RETRIES is the number of frame-layer retry commands sent without receiving a
response executed before a link is considered disconnected and is reset (all counters
set to 0).
L2RETRIES is the network subscription parameter N2.
The value can be altered with the SCF line attribute RETRIES.
L2TIMEOUT n
L2TIMEOUT is the time interval spent waiting for a frame-layer response before
retrying a frame-layer request.
L2TIMEOUT is the network subscription parameter T1.
The value can be altered with the SCF line attribute T1TIMEOUT.
Note: Not in effect (L2IFRAMERECOVERY is not supported)
Default: L2NODISC
Units: Not applicable
Alternate Modifier: L2DISC
Default: 10
Units: Number of retries (in integers)
Range: 0 through 255
Default: 300 (3 seconds)
Value: .01 seconds
Range: 0 through 32767 (5 minutes, 27.67 seconds)