X25AM Configuration and Management Manual

Configuring an X25AM Subsystem
X25AM Configuration and Management Manual—523424-004
3-28
Numeric Range Validation
NOAUTOLOAD. See AUTOLOAD
NOCALLS. See TWOWAYCALLS
NOCALLUSERDATA. See CALLUSERDATA
NOEXTFORMAT
NOEXTFORMAT or EXTFORMAT specifies whether to enable or disable extended
format packets for Call Request, Call Accepted, Clear, and Clear Confirmation packets.
NOEXTFORMAT disables extended packets. X25AM rejects these extended format
packets. EXTFORMAT enables extended packets.
If you use the fast-select facility and the PACKETSIZE is less than 256 bytes, you must
set EXTFORMAT to ON in the profile (for G-series or H-series and later RVUs) or
configure the X25 line for extended format by SYSGEN (for D-series RVUs).
If the packet size is greater than or equal to 256, you can use the SCF line attribute
EXTFORMAT to alter the value of NOEXTFORMAT in X25AM.
NOINCOMINGCALLS. See TWOWAYCALLS
NOOUTGOINGCALLS. See TWOWAYCALLS
NOREPORTREDIRECT
NOREPORTREDIRECT or REPORTREDIRECTION specifies whether a user-coded
application can retrieve a data terminal equipment (DTE) address by using a
SETPARAM 1 command.
NOSENDCALLINGADDRESS. See SENDCALLINGADDRESS
SENDSTOP
When set, this modifier causes the modem signals to be dropped when the SCF
ABORT/STOP command is issued.
Default: NOEXTFORMAT
Units: Not applicable
Alternate Modifier: EXTFORMAT
Default: NOREPORTREDIRECT
Units: Not applicable
Alternate Modifier: REPORTREDIRECTION
Default: Not set
Units: Not applicable