X25AM Configuration and Management Manual

Configuring an X25AM Subsystem
X25AM Configuration and Management Manual—523424-004
3-30
Numeric Range Validation
POOLPAGES. See EXTENDEDPOOLPAGES
Profile^Version
Profile^Version gives a version to the profile configured for use by an X25AM I/O
process. The profile version must match the version with which the X25AM I/O process
is configured to be used.
PROGRAM download-filename
PROGRAM identifies the Kernel-based 510 microcode file, where the data link control
(DLC) task is located. This file is downloaded to the SWAN concentrator CLIP RAM
memory when the line is started.
Replace the default for PROGRAM only if you are:
•
Using a SWAN 2 concentrator (use modifier C1096Q00 instead)
•
Implementing an X.21 interface that has an X.21 converter cable (for SWAN
concentrator (T3880), use modifier C0051P00; for a SWAN 2 concentrator, use
modifier C0051Q00).
This modifier is listed only as C1096P00, C0051P00, C1096Q00, or C0051Q00 among
the device modifiers in the INFO DEVICE command’s output.
RS232
RS232 or RS422 selects the hardware protocol used for the line. The value is
determined by the electrical interface supported by the modem.
The value can be altered with the SCF line attribute INTERFACE.
Default: Not set
Units: Not applicable
Range: None
Default: filename = $SYSTEM.CSSnn.C1096P00
Units: Not applicable
Alternate Modifiers: $SYSTEM.CSSnn.C0051P00, $SYSTEM.CSSnn.C1096Q00,
and $SYSTEM.CSSnn.C0051Q00
Default: RS232
Units: Not applicable
Alternate Modifiers: RS422 (equivalent to RS449)