X25AM Configuration and Management Manual

Configuring an X25AM Subsystem
X25AM Configuration and Management Manual—523424-004
3-31
Numeric Range Validation
RS422. See RS232
Rxx n. See Txx n
SENDCALLINGADDRESS
SENDCALLINGADDRESS or NOSENDCALLINGADDRESS specifies whether or not a
default address is used in the calling address field of outgoing call request packets.
•
SENDCALLINGADDRESS: Uses the address assigned to the line (with the SCF
line attribute SRCADDR) as the calling address. You should concatenate a port
number with the address specified with SRCADDR or NETADDR if allowed by the
network.
•
NOSENDCALLINGADDRESS: Uses a zero-length calling address.
The value can be altered with the SCF line attribute CALLINGADDR.
SENDSTOP
When set, this modifier causes the modem signals to be dropped when an SCF
ABORT/STOP command is issued.
STRIPPARITY
STRIPPARITY or NOSTRIPPARITY specifies whether or not the parity bit is stripped
from data transferred to the application buffer. This is a subdevice-dependent option
(parity-setting and parity-checking are subdevice attributes). Parity applies only to ITI
subdevices set to conversation mode: it does not apply to PTP subdevices.
STRIPPARITY can also serve as a workaround for terminals that must transmit 8-bit
characters, such as accented vowels in some European languages.
Default: SENDCALLINGADDRESS
Units: Not applicable
Alternate Modifier: NOSENDCALLINGADDRESS
Default: Not set
Units: Not applicable
Default: STRIPPARITY
Units: Not applicable
Alternate Modifier: NOSTRIPPARITY
Note: Only applies to ITI subdevices set to conversation mode