X25AM Configuration and Management Manual

SCF Commands for the X25AM Subsystem
X25AM Configuration and Management Manual—523424-004
4-10
Commands Supported by the X25AM Subsystem
Commands Supported by the X25AM
Subsystem
This section describes the SCF commands supported by the X25AM subsystem (see
Table 4-3). For information about commands supported by other subsystems, see the
SCF manual for the specific subsystem, or see the SCF Reference Manual for G-
Series RVUs or SCF Reference Manual for H-Series RVUs.
You can receive detailed syntax information on the X25AM object types and the
commands that apply to them when you enter the following SCF command:
-> HELP X25AM object-type [ command ]
For more detailed information about the online help facility, see the SCF Reference
Manual for G-Series RVUs or SCF Reference Manual for H-Series RVUs.
Alter subdevices Yes No
Monitor I/O processes No Yes
Monitor lines Yes No
Monitor subdevices Yes No
* Adding an I/O process effectively adds an X25AM line
**You can switch an X25AM I/O process to another path, and you can make the backup processor the primary
processor
Table 4-3. SCF Commands Supported by X25AM Subsystem (page 1 of 2)
Command PROCESS LINE SU
ABORT X X
ADD X
ALLOWOPENS X X
ALTER X X
DELETE * X
DISCONNECT X
INFO X X
NAMES X X
PRIMARY X X
START X X
STATS X X
STATUS X X
Table 4-2. Configuring and Managing X25AM Objects With SCF
Commands (page 2 of 2)
Task X25AM Subsystem WAN Subsystem