X25AM Configuration and Management Manual

SCF Commands for the X25AM Subsystem

X25AM Configuration and Management Manual—523424-004

4-11

Sensitive and Nonsensitive Commands

Because some commands can have detrimental effects if improperly used, special

qualification is required to use them. These commands are sensitive. Commands that

request information or status but that do not affect operation are nonsensitive.

Only a user who has super-group access, the owner of the subsystem, or a member of

the group of the owner of the subsystem can issue a sensitive command.

The owner of a subsystem is the user who started that subsystem (or any user whose

application ID is the same as the server ID—the result of a PROGID option that

requires super-group access). Anyone can issue a nonsensitive command.

The following SCF commands for the X25AM subsystem are sensitive:

ABORT PRIMARY

ADD START

ALLOWOPENS STOP

ALTER STOPOPENS

DELETE SWITCH

DISCONNECT TRACE

The following SCF commands for X25AM are nonsensitive; you use them to determine

the status of SCF or to display information about an object.

INFO STATUS

NAMES VERSION

STATS

STOP X X

STOPOPENS X X

SWITCH X X

TRACE X

VERSION X X

* Supported for LINE object with SUB ONLY option.

Table 4-3. SCF Commands Supported by X25AM Subsystem (page 2 of 2)

Command PROCESS LINE SU