X25AM Configuration and Management Manual

SCF Commands for the X25AM Subsystem
X25AM Configuration and Management Manual—523424-004
4-22
Considerations for the ALTER Command
The following command sets the CUD for the subdevice named $X25P1.#TERM:
-> ALTER SU $x25p1.#term, CUD “1234”
Considerations for the ALTER Command
•
The line or subdevice must be in the STOPPED state before you can alter its
attributes.
•
An attribute can appear only once in a single ALTER command.
•
After you alter a line with the ALTER command, use the INFO command to check
the attributes, and then restart the line with the START command.
•
Use the INFO, DETAIL command to check which attributes are alterable. Attributes
with an asterisk (*) on the left side are alterable.
•
You must enter the LIKE object-name option before you enter any
attribute-spec.
•
NEGOTIATE can be applied only to switched virtual circuit (SVC) subdevices. If
you configure a permanent virtual circuit (PVC) incorrectly with the NEGOTIATE
attribute, X25AM does not issue an error message. However, the NEGOTIATE
attribute will have no effect on the subdevice.
The following is a list of X25AM I/O process modifiers for which there is no equivalent
SCF line attribute:
Table 4-4 on page 4-23 lists the attributes that you can configure with either the SCF
ALTER DEVICE command (X25AM I/O process modifiers) to the WAN subsystem or
the SCF ALTER LINE command (SCF line attributes) to the X25AM subsystem.
AUTOLOAD L2DOWNLINE NOSTRIPPARITY
DISABLEPVCOUTOFORDER L2NODISC PACKETSIZE
DRTIMEOUT L2WINDOW POOLPAGES
EMSFORCLEAR L3RECVTHRUPUT REPORTDIRECT
ENABLEPVCOUTOFORDER L3SENDTHRUPUT Rxx
ENABLECALLEDADDREXT MAXIOSIZE STRIPPARITY
EXTENDEDPOOLPAGES NOAUTOLOAD TYPE
FIFO NOEMSFORCLEAR Txx
IDLECMDRR NOL2DOWNLINE UNSOLF
IDLERESPRR NOREPORTDIRECT X25V
L2DISC