X25AM Management Programming Manual

X25AM Management Programming Manual—528037-001
ix
About This Manual
This manual provides subsystem-specific programming information about the
management-programming interface provided by HP for managing the X25AM
subsystem. This interface is based on the Subsystem Programmatic Interface (SPI)
and the Event Management System (EMS).
This manual serves as both a reference manual and a programmer's guide for the
development of management applications that use the X25AM subsystem.
Who Should Use This Manual
This manual is for experienced application programmers in one of the following
categories:
•
TAL programmers, and COBOL85 programmers using ENTER TAL, who are
writing applications that control or monitor the X25AM subsystem.
•
TACL users who are writing macros or routines that control or monitor the X25AM
subsystem.
What’s in This Manual
Table i. Summary of Contents (page1of2)
Section This section...
Section 1, Introduction
Provides introduction to X25AM subsystem, and
architecture of the X25AM subsystem.
Section 2, Management
Programming for the X25AM
Subsystem
Describes how an application uses the management-
programming interfaces, and provides details of all
programmatic commands that can be sent to the X25AM
subsystem and their corresponding responses.
Section 3, Elements for SPI
Messages for the X25AM
Subsystem
Discuses the elements of SPI messages for the X25AM
subsystem.
Section 4, SPI Programming
Considerations for the X25AM
Subsystem
Discusses SPI programming considerations that are
specific to the X25AM subsystem.
Section 5, Common
Definitions
Provides general information that applies to all uses of the
definitions in the interface to the X25AM subsystem; SPI
standard definitions, EMS standard definitions, and data-
communications standard definitions.
Section 6, Commands and
Responses
Describes the syntax and semantics for all commands and
responses in the programmatic control-and-inquiry interface
to the X25AM subsystem.