X25AM Management Programming Manual

About This Manual
X25AM Management Programming Manual—528037-001
x
Related Manuals
Related Manuals
This manual assumes that you are familiar with HP NonStop™ system architecture,
have a reading knowledge of DDL, and have a working knowledge of both the X25AM
subsystem and the languages in which you are programming: TAL, COBOL85, or
TACL. Before using this manual, therefore, you should be familiar with the material
covered in these manuals:
•
Introduction to Tandem NonStop Systems
•
Data Definition Language (DDL) Reference Manual (only a reading familiarity with
DDL is required)
•
Introduction to Tandem X.25 Capabilities
•
The manuals describing the programming languages being used
In addition, this manual assumes that you are familiar with system and network
management. Before using this manual, you should be familiar with the material
covered in the following manuals, which contain general information about system and
network management, SPI, EMS, and the management of data-communications
subsystems such as the X25AM subsystem.
•
Introduction to Distributed Systems Management (DSM) (D-series only)
•
SPI Programming Manual
•
EMS Manual
•
SPI Common Extensions Manual
This manual makes frequent references to the SPI Programming Manual, the EMS
Manual, and the SPI Common Extensions Manual for further information.
Section 7, Event Management Describes the event messages that the X25AM subsystem
can issue and the specific programming considerations for
dealing with X25AM event messages in an application.
Section A, Error Numbers and
Error Lists
Describes the error numbers that are provided by the
X25AM subsystem (that is, the values whose symbolic
names begin with ZX25-ERR-).
Section B, Token Codes and
Token Maps
Lists all token codes and token maps specific to the X25AM
subsystem.
Table i. Summary of Contents (page2of2)