X25AM Management Programming Manual

Commands and Responses
X25AM Management Programming Manual—528037-001
6-72
INFO Command
ZCALLS
indicates the types of call requests allowed. This field can have one of the
following values:
ZCKT-NUM
contains the number of circuits for this line.
ZCHAR-SET
indicates the character set being used by the controller. This field can have one
of the following values:
This field applies only to the 6201 controller.
ZCONV-PAD-CNT
contains the number of parameter pairs that appear in the field ZCONV-PAD-
PARAMS. If the value of this field is 0, it indicates that there are no explicitly
specified conversational-mode PAD parameters. This field has no
corresponding SYSGEN modifier.
ZCONV-PAD-PARAMS
contains from 0 through 63 pairs of integers that specify the conversational-
mode X.29 PAD parameters. The number of integer pairs in this field is given
by the value of the field ZCONV-PAD-CNT. PAD parameters are meaningful
only if the subdevice protocol is ITI. This field has no corresponding SYSGEN
modifier.
ZX25-VAL-INCOMING-CALLS Only incoming call requests are allowed. This
value corresponds to the SYSGEN modifier
INCOMINGCALLS, NOOUTGOINGCALLS.
ZX25-VAL-NO-CALLS No call requests are allowed. This value
corresponds to the SYSGEN modifier NOCALLS.
ZX25-VAL-OUTGOING-CALLS Only outgoing call requests are allowed. This
value corresponds to the SYSGEN modifier
OUTGOINGCALLS, NOINCOMINGCALLS.
ZX25-VAL-TWO-WAY-CALLS Both incoming and outgoing call requests are
allowed. This value corresponds to the SYSGEN
modifier TWOWAYCALLS.
ZX25-VAL-CHAR-SET-ASCII The controller is using the ASCII character set.
This value corresponds to the SYSGEN
modifier ASCII.
ZX25-VAL-CHAR-SET-EBCDIC The controller is using the EBCDIC character
set. This value corresponds to the SYSGEN
modifier EBCDIC.