X25AM Management Programming Manual

Commands and Responses
X25AM Management Programming Manual—528037-001
6-73
INFO Command
ZCUG
contains the closed user group (CUG) identification that is sent in every call-
request packet. This value establishes a default value that is used when the
CUG identification attribute of a subdevice is not specified. If this field contains
its null value, there is no explicitly specified CUG identification. This field
corresponds to the SYSGEN modifier CUG.
ZDEBUG
indicates whether or not debugging of the Communications Line Interface
Processor (CLIP) software is enabled. This field is meaningful only for 6100 or
6105 X25AM lines, and it can have the following values:
This field is intended for HP use only. This field has no corresponding
SYSGEN modifier.
ZDSR-TIMEOUT
contains the time interval that the CLIP will wait for the Data Set Ready (DSR)
signal from the modem. If the CLIP does not receive the DSR signal within that
time, it informs the line-handler process that it did not detect DSR. This field
corresponds to the SYSGEN modifier DSRTIMER.
ZEXT-CALL-FORMAT
indicates whether or not the reception of larger-than-normal packets using the
fast-select feature is enabled. This field can have one of the following values:
ZFRAME-MODE
indicates whether the station is Data Circuit-terminating Equipment (DCE) or
Data Terminal Equipment (DTE). This field can have one of the following
values:
ZSPI-VAL-TRUE Debugging of the CLIP software is enabled.
ZSPI-VAL-FALSE Debugging of the CLIP software is disabled.
ZSPI-VAL-TRUE The reception of larger-than-normal packets is enabled.
This value corresponds to the SYSGEN modifier
EXTFORMAT.
ZSPI-VAL-FALSE The reception of larger-than-normal packets is disabled.
This value corresponds to the SYSGEN modifier
NOEXTFORMAT.
ZX25-VAL-FRAME-MODE-DCE The station is DCE. This value corresponds to
the SYSGEN modifier DCE.
ZX25-VAL-FRAME-MODE-DTE The station is DTE. This value corresponds to
the SYSGEN modifier DTE.