X25AM Management Programming Manual

Commands and Responses
X25AM Management Programming Manual—528037-001
6-76
INFO Command
ZPKT-SIZE
contains the packet size.
ZPAGE6520-BLOCK-SIZE
contains the block size for ITI 6520 and 6530 terminals. This field corresponds
to the SYSGEN modifier PAGE6520BLKSIZE.
ZPROG
contains the file name of the program to be downloaded to the CLIP. This field
is meaningful only for 6100, 6105, or 3605 X25AM lines. This field corresponds
to the SYSGEN modifier PROGRAM.
ZPVC-RANGE
is a pair of integers that contains the range of logical channels that are used for
Permanent Virtual Circuits (PVCs). The first integer of the pair specifies the
lower end of the range, and the second integer specifies the upper end. If this
field contains its null value, there is no explicitly specified range. This field has
no corresponding SYSGEN modifier.
ZRETRIES
contains the number of level-2 retries to be attempted before a disconnect
(N2). This field corresponds to the SYSGEN modifier L2RETRIES.
ZREXMIT-TIMEOUT
contains the time interval to wait for an acknowledgment before a
retransmission is attempted (the level-2 T1-timer interval). This field
corresponds to the SYSGEN modifier L2TIMEOUT.
ZSTART-DOWN
indicates whether or not a line will come up automatically after a cold load. This
field can have one of the following values:
ZX25-VAL-NETID-X25SA The addressing conventions of the generic netid
X25SA are being used. This value corresponds
to the SYSGEN modifier X25SA.
ZX25-VAL-NETID-X25UD The addressing conventions of the generic netid
X25UD are being used. This value corresponds
to the SYSGEN modifier X25UD.
ZX25-VAL-NETID-X25XA The addressing conventions of the generic netid
X25XA are being used. This value corresponds
to the SYSGEN modifier X25XA.
ZSPI-VAL-TRUE The line must be brought up by a command.
ZSPI-VAL-FALSE The line will come up automatically.