X25AM Management Programming Manual
Commands and Responses
X25AM Management Programming Manual—528037-001
6-77
INFO Command
This field corresponds to the SYSGEN modifier STARTDOWN.
ZSRC-ADDR
contains the X.25 network address for your system. This field has no
corresponding SYSGEN modifier.
ZFILLER
acts as a filler and is not associated with any line attribute. This field has no
corresponding SYSGEN modifier.
ZSVC-RANGE
is a pair of integers that contains the range of logical channels that are used for
Switched Virtual Circuits (SVCs). The first integer of the pair specifies the lower
end of the range, and the second integer specifies the upper end. If this field
contains its null value, there is no explicitly specified range. This field has no
corresponding SYSGEN modifier. The first integer of the pair must be greater
than the second integer of the PVC range.
ZSYNCS
contains the number of SYN characters that are transmitted before each frame.
This field applies only to the 6201 controller, and it corresponds to the
SYSGEN modifier SYNCS.
ZTHRES
contains the number of frames that are sent and received before line quality is
checked. This field corresponds to the SYSGEN modifier
LINEQUALITYTHRESHOLD.
ZCUG-TYPE
specifies which CUG facility is selected. This field can be assigned the
following values:
If the CUG ID is configured to be 99 or less, then the CUGTYPE can be any of
the four values. The default in this case is BASIC.
ZX25-VAL-CUG-TYPE-BASIC Basic format CUG selection
ZX25-VAL-CUG-TYPE-EXT Extended format CUG selection
ZX25-VAL-CUG-TYPE-BASICOA Basic format CUG with outgoing access
selection
ZX25-VAL-CUG-TYPE-EXTOA Extended format CUG with outgoing access
selection If the CUG ID is reset or is not
configured, CUGTYPE contains the default
value BASIC.