X25AM Management Programming Manual

Commands and Responses
X25AM Management Programming Manual528037-001
6-78
INFO Command
If the CUG ID is configured to be greater than 99, then the CUGTYPE must be
EXT or EXTOA. The default in this case is EXT.
ZBCUG
specifies the bilateral closed user group ID sent in every call-request packet.
The line BCUG establishes a default value that is used when the subdevice
BCUG attribute is not specified. The range is 0 through 9999.
ZRPOA
specifies the Recognized Private Operating Agency (RPOA) transit network(s)
in the facility field of a call-request packet. The line RPOA establishes a default
value that is used when the subdevice RPOA attribute is not specified.
An RPOA transit network is indicated by the Data Network Identification Code
(DNIC), which is an integer in the range 0 through 9999.
ZRPOA-DNIC-CNT
specifies the number of DNICs listed in the ZRPOA field. The range is 0
through 7.
ZTRANSIT-DELAY
specifies the transit delay in the facility field of a call-request packet. The line
TRANSITDELAY establishes a default value that is used when the subdevice
TRANSITDELAY attribute is not specified. The value is in TIMESTAMP format
with a range of 0 through 6533 hundredths of a second.
ZMAX-IO-SIZE
specifies the maximum user I/O buffer size in bytes. This value is used for ITI
and PTP protocols. When used with a PTP subdevice, the size does not
include the Message Control Word. The range is 1 through 64K bytes. The
default is 4096 bytes.
ZX25-MAP-INFO-SU is present in the response record if the token ZCOM-TKN-
OBJTYPE contains the value ZCOM-OBJ-SU. It has the token number ZX25-TNM-
INFO-SU and the DDL definition ZX25-DDL-INFO-SU. This token contains the
following fields:
ZDEV-TYPE
is a pair of integers that contains the device type and subtype of the subdevice.
The first integer is the device type, which depends on the protocol being used.