X25AM Management Programming Manual

Commands and Responses
X25AM Management Programming Manual—528037-001
6-84
INFO Command
ZLOCAL-ADDR-EXT-TYPE
specifies the status of ZLOCAL-ADDR-EXT. This field can be assigned the
following values:
ZREMOTE-ADDR-EXT-TYPE
specifies the status of ZREMOTE-ADDR-EXT. This field can be assigned the
following values:
ZPAGE6520-BLOCK-SIZE
specifies the block size used in the ITI protocol. This modifier supports
terminals that emulate the HP 6520 or 6530 terminal with a nonstandard block
size in block mode. The range is 0 through 8000. The default is 256.
ZAUTO-DEL-SU
specifies that the PTP subdevice is automatically deleted when the last opener
closes the subdevice.
ZCUG-TYPE
specifies which CUG facility is selected. This field can be assigned the
following values:
If the CUG ID is reset or is not configured, CUGTYPE contains the default
value BASIC.
If the CUG ID is configured to be 99 or less, then the CUGTYPE can be any of
the four values. The default in this case is BASIC. If the CUG ID is configured
to be greater than 99, then the CUGTYPE must be EXT or EXTOA. The default
in this case is EXT.
0Full NSAP
1Reserved
2Non-OSI
3Reserved
0Full NSAP
1Reserved
2Non-OSI
3Reserved
ZX25-VAL-CUG-TYPE-BASIC Basic format CUG selection
ZX25-VAL-CUG-TYPE-EXT Extended format CUG selection
ZX25-VAL-CUG-TYPE-BASICOA Basic format CUG with outgoing access
selection
ZX25-VAL-CUG-TYPE-EXTOA Extended format CUG with outgoing access
selection