X25AM Management Programming Manual

Commands and Responses
X25AM Management Programming Manual—528037-001
6-147
TRACE Command
Duplicate occurrences of ZCOM-TKN-TRACE-OPT are allowed, so that more than
one option can be selected.
(ZSPI-TKN-) MAXRESP, CONTEXT, RESPONSE-TYPE, ALLOW-TYPE, and
COMMENT
are standard SPI tokens described in the SPI Programming Manual. With the
exception of ZSPI-TKN-COMMENT, duplicate occurrences of these tokens are not
allowed.
Tokens in Response Buffer
ZSPI-TKN-DATALIST
is a standard SPI data list, as described in the SPI Programming Manual. The list
ends with the token ZSPI-TKN-ENDLIST.
ZSPI-TKN-MANAGER
is a standard SPI manager token that contains the name of an X25AM line. This
token is present in every response record. ZSPI-TKN-MANAGER is described in
Section 5, Common Definitions.
ZCOM-TKN-OBJNAME
is an object-name token that contains the name of the line that was affected by the
command. If there is no error, this token is present in every response record.
ZCOM-TKN-OBJNAME is described in Section 5, Common Definitions.
ZCOM-TKN-OBJTYPE
is an object-type token that contains the value ZCOM-OBJ-LINE. This token is
present in every response record, and it is described in the SPI Common
Extensions Manual.
ZX25-VAL-TRACE-OPT-CLIPDI CLIP inbound frames are to be traced. (This
option is valid only for 6100 X25AM lines).
The option ZX25-VAL-TRACE-OPT-CLIP
must also be selected for this tracing to occur.
ZX25-VAL-TRACE-OPT-CLIPDO CLIP outbound frames are to be traced. (This
option is valid only for 6100 X25AM lines).
The option ZX25-VAL-TRACE-OPT-CLIP
must also be selected for this tracing to occur.
ZX25-VAL-TRACE-OPT-CLIPL2 CLIP level-2 events are to be traced. (This
option is valid only for 6100 X25AM lines).
The option ZX25-VAL-TRACE-OPT-CLIP
must also be selected for this tracing to occur.