X25AM Management Programming Manual

Event Management
X25AM Management Programming Manual—528037-001
7-44
147: ZX25-EVT-CSS-PROBE-ERROR
Recovery. Analyze the failure by looking at the CSM error code given by param3 in
the text message and at the accompanying event or error message. Then issue a CMI
STOP command against the object before trying to start it again.
147: ZX25-EVT-CSS-PROBE-ERROR
The 6100 Communications Subsystem Manager (CSM) received a status probe
response from the Communications Line Interface Processor (CLIP) indicating it is in
the boot state instead of the run state. This event is a critical event, and the event
message is reported to the EMS collector, $0.
This event message is equivalent to console message 147.
ZSPI-TKN-SSID
is the X25AM subsystem ID, and its value is ZX25-VAL-SSID. This token is
described in the SPI Programming Manual.
ZEMS-TKN-EVENTNUMBER
is the event number, as described in the EMS Manual. Its value is ZX25-EVT-CSS-
PROBE-ERROR (147).
ZEMS-TKN-SUBJECT-MARK
is the standard EMS token that always immediately precedes the subject token--
here, ZEMS-TKN-LDEVNAME.
Tokens
ZSPI-TKN-SSID token-type ZSPI-TYP-SSID.
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-ENUM.
ZEMS-TKN-SUBJECT-MARK token-type ZSPI-TYP-MARK.
ZEMS-TKN-LDEVNAME token-type ZSPI-TYP-FNAME32.
ZEMS-TKN-LDEV token-type ZSPI-TYP-UINT.
ZEMS-TKN-EMPHASIS token-type ZSPI-TYP-BOOLEAN.
ZEMS-TKN-CONSOLE-PRINT token-type ZSPI-TYP-BOOLEAN.
ZEMS-TKN-CPU token-type ZSPI-TYP-UINT.
ZEMS-TKN-CRTPID token-type ZSPI-TYP-CRTPID.
ZEMS-TKN-GENTIME token-type ZSPI-TYP-TIMESTAMP.
ZEMS-TKN-LOGTIME token-type ZSPI-TYP-TIMESTAMP.
ZEMS-TKN-PIN token-type ZSPI-TYP-UINT.
ZEMS-TKN-SYSTEM token-type ZSPI-TYP-UINT.
ZEMS-TKN-USERID token-type ZSPI-TYP-BYTE-PAIR.
ZEMS-TKN-CU token-type ZSPI-TYP-UINT.
ZEMS-MAP-EXIOADDR token-type ZSPI-TYP-EXIOADDR.
Event-Message Text
LDEV ldev [ CU %ccu ] X25: CSS STATUS PROBE ERROR,
CIU path %param3 %param4