X25AM Management Programming Manual

Event Management
X25AM Management Programming Manual—528037-001
7-45
147: ZX25-EVT-CSS-PROBE-ERROR
ZEMS-TKN-LDEVNAME
is the name of the X25AM line that is the subject of this event message. This token
is described in the EMS Manual.
ZEMS-TKN-LDEV
is the logical device number of the X25AM line that is the subject of this event
message. It corresponds to the value ldev in the text message. This token is
described in the EMS Manual.
ZEMS-TKN-EMPHASIS
contains the value ZSPI-VAL-TRUE, indicating that this event is a critical event.
This token is described in the EMS Manual.
ZEMS-TKN-CONSOLE-PRINT
contains the value ZSPI-VAL-TRUE. This token is described in the EMS Manual.
(ZEMS-TKN-) CPU, CRTPID, GENTIME, LOGTIME, PIN, SYSTEM, and
USERID
are standard EMS tokens described in the EMS Manual.
ZEMS-TKN-CU
is a standard EMS token that contains the controller and unit number. It
corresponds to the value ccu in the text message. This token is present only when
the event reports a possible HP hardware error and the device physical address is
an old subchannel type.
ZEMS-MAP-EXIOADDR
is a standard EMS token described in the EMS Manual.
In the message text, ldev corresponds to the value of ZEMS-TKN-LDEV and ccu
corresponds to the value of ZEMS-TKN-CU. The values path, param3, and param4
do not correspond to the values of tokens in the event message.
The value param3 contains the CLIP status byte, which is decoded as described
below.
If the value in param3 is %377 or less, the rightmost byte of the value is interpreted as
follows.
If the Not Owner bit is equal to 1, the status was received from the backup port, which
does not respond to a large number of commands.
Bit: 0 1 2 3 4 5 6 7
Not
Owner
In
Boot
Error