X25AM Management Programming Manual

Event Management
X25AM Management Programming Manual—528037-001
7-48
152: ZX25-EVT-CSS-CLB-CMD-REJECT
ZEMS-TKN-LDEV
is the logical device number of the X25AM line that is the subject of this event
message. It corresponds to the value ldev in the text message. This token is
described in the EMS Manual.
ZEMS-TKN-EMPHASIS
contains the value ZSPI-VAL-TRUE, indicating that this event is a critical event.
This token is described in the EMS Manual.
ZEMS-TKN-CONSOLE-PRINT
contains the value ZSPI-VAL-TRUE. This token is described in the EMS Manual.
(ZEMS-TKN-) CPU, CRTPID, GENTIME, LOGTIME, PIN, SYSTEM, and USERID
are standard EMS tokens described in the EMS Manual.
In the message text, ldev corresponds to the value of ZEMS-TKN-LDEV. The values
ccu, path, param3, param4, and param5 do not correspond to the values of tokens
in the event message.
The value param3 contains the CIU-to-LIU Bus (CLB) frames A and C.
The value param4 contains the sequence number and the cause of the error. The
sequence number is stored in the most significant eight bits of the value. The cause of
the command reject is stored in the least significant eight bits of the value, and is
indicated by one of the following values:
The value param5 contains the C-field and the sequence number of the rejected
command.
Cause. The BOB of the 6100 CSS was not properly synchronized with the host. It is
normal for this event to occur when the BOB is powered on or powered off, or when
processors are switched.
Effect. In most cases, the BOB and the host recover (become properly synchronized
again) without any user action.
Recovery. If the error persists, contact your HP representative.
0 The message checksum was invalid.
1 The command sequence number was invalid.
2 The command code was invalid.
3 A command parameter was invalid.