X25AM Management Programming Manual

Event Management
X25AM Management Programming Manual—528037-001
7-50
156: ZX25-EVT-CSS-NO-RESPONSE
ZEMS-TKN-LDEV
is the logical device number of the X25AM line that is the subject of this event
message. It corresponds to the value ldev in the text message. This token is
described in the EMS Manual.
ZEMS-TKN-EMPHASIS
contains the value ZSPI-VAL-TRUE, indicating that this event is a critical event.
This token is described in the EMS Manual.
ZEMS-TKN-CONSOLE-PRINT
contains the value ZSPI-VAL-TRUE. This token is described in the EMS Manual.
(ZEMS-TKN-) CPU, CRTPID, GENTIME, LOGTIME, PIN, SYSTEM, and USERID
are standard EMS tokens described in the EMS Manual.
ZEMS-TKN-CU
is a standard EMS token that contains the controller and unit number. It
corresponds to the value ccu in the text message. This token is present only when
the event reports a possible HP hardware error and the device physical address is
an old subchannel type.
ZEMS-MAP-EXIOADDR
is a standard EMS token described in the EMS Manual.
In the message text, ldev corresponds to the value of ZEMS-TKN-LDEV and ccu
corresponds to the value of ZEMS-TKN-CU. The values path, param3, and param4
do not correspond to the values of tokens in the event message.
The value param3 contains the SEND state of the CLIP. The value param4 contains
the RECEIVE state of the CLIP.
Cause. The CLIP failed to respond to a periodic probe by a line-handler process, and
a NO RESPONSE message was received.
Effect. In most cases, the affected I/O process attempts recovery.
Recovery. Analyze the information in the values param3 and param4 of the text
message to determine the reason for the error, and contact your HP representative.