X25AM Management Programming Manual

Management Programming for the X25AM
Subsystem
X25AM Management Programming Manual—528037-001
2-4
Commands an Application Can Issue
Table 2-3 on page 2-5 shows the correspondence between the Communications
Management Interface (CMI) commands you use to control and inquire about the
X25AM subsystem and the corresponding programmatic commands you send to the
X25AM subsystem. To make the contrast between the two kinds of commands clear,
the table uses the command and object names in the full form you must use in
programs. In text and in the headings for the command descriptions, the commands
and object types appear in a shortened form (without the ZCOM-CMD- and ZCOM-
OBJ- prefixes).
None ZCOM-CMD-GETVERSION ZCOM-OBJ-NULL
INFO LINE
INFO SUBDEVICE
ZCOM-CMD-INFO
ZCOM-CMD-INFO
ZCOM-OBJ-LINE
ZCOM-OBJ-SU
NAMES LINE
NAMES SUBDEVICE
NAMES NULL
ZCOM-CMD-LISTOBJECTS
ZCOM-CMD-LISTOBJECTS
ZCOM-CMD-LISTOBJECTS
ZCOM-OBJ-LINE
ZCOM-OBJ-SU
ZCOM-OBJ-NULL
PRIMARY LINE
PRIMARY PROCESS
ZCOM-CMD-SWITCH
ZCOM-CMD-SWITCH
ZCOM-OBJ-LINE
ZCOM-OBJ-PROCESS
START LINE
START SUBDEVICE
ZCOM-CMD-START
COM-CMD-START
ZCOM-OBJ-LINE
ZCOM-OBJ-SU
STATUS LINE
STATUS SUBDEVICE
ZCOM-CMD-STATUS
ZCOM-CMD-STATUS
ZCOM-OBJ-LINE
ZCOM-OBJ-SU
STATS LINE
STATS SUBDEVICE
STATS LINE, RESET
ZCOM-CMD-STATISTICS
ZCOM-CMD-STATISTICS
ZCOM-CMD-RESETSTATS
ZCOM-OBJ-LINE
ZCOM-OBJ-SU
ZCOM-OBJ-LINE
STATS SUBDEVICE, RESET ZCOM-CMD-RESETSTATS ZCOM-OBJ-SU
STOP LINE
STOP SUBDEVICE
ZCOM-CMD-STOP
ZCOM-CMD-STOP
ZCOM-OBJ-LINE
ZCOM-OBJ-SU
STOPOPENS LINE
STOPOPENS SU
ZCOM-CMD-FORBIDOPENS
ZCOM-CMD-FORBIDOPENS
ZCOM-OBJ-LINE
ZCOM-OBJ-SU
SWITCH PROCESS ZCOM-CMD-SWITCH
ZCOM-CMD-SWITCH
ZCOM-OBJ-LINE
ZCOM-OBJ-PROCESS
TRACE LINE ZCOM-CMD-TRACE ZCOM-OBJ-LINE
Table 2-2. SCF Commands and Programmatic Commands (page 2 of 2)
SCF Command and Object
Type Programmatic Command and Object Type