X25AM Management Programming Manual

Management Programming for the X25AM

Subsystem

X25AM Management Programming Manual—528037-001

2-6

Event Messages

In addition to sending commands and receiving responses, a management application

can obtain notification of events that occur in the X25AM subsystem. This notification is

in the form of event messages that are issued by the X25AM subsystem. An event

message describes an event such as a hardware or software error or the completion of

an operation. Your application could monitor these event messages to handle

unexpected situations or to keep track of the current status of the system and the

network.

The event messages that can be issued by the X25AM subsystem are described in

Section 7, Event Management.

Prerequisite Manuals

This manual provides subsystem-specific information about using the programmatic

control-and-inquiry interface to communicate with the X25AM subsystem and about the

event messages generated by the X25AM subsystem. To use the material in this

manual, you must be familiar with the information provided in these manuals:

•

The SPI Programming Manual, describes the Subsystem Programmatic Interface

(SPI), which is used for management programming of HP subsystems. SPI

provides a set of procedure calls and a set of definition files to be used in

management programs.

•

The EMS Manual, which contains information about obtaining event messages,

defining filters, and so on.

•

The SPI Common Extensions Manual, describes a common set of extensions to

the basic SPI. This common interface includes the Subsystem Control Point (SCP)

process and a set of common data, event, and error definitions (ZCOM and

ZCMK).

None

STOP SUBDEVICE

ZCOM-CMD-STOP

ZCOM-OBJ-LINE

ZCOM-OBJ-SU

TRACE LINE ZCOM-CMD-TRACE ZCOM-OBJ-LINE

Table 2-3. CMI Commands and Programmatic Commands (page2of2)

CMI Command and Object

Type Programmatic Command and Object Type